Specifications - Omron E3M-V Manual

E3M-V

Specifications

Ratings/Characteristics
Item
Sensing distance 10 3 mm
Spot size (W x H) 1 x 4 mm
Light source Green LED (525 nm)
(wavelength)
Power supply voltage 10 to 30 VDC, ripple (p–p) 10% max.
Current consumption 100 mA max.
Control output Load power supply voltage:
Load current:
(Residual voltage: 1.2 V max.)
NPN open collector output type
Remote control input ON: Short-circuited to 0 or 1.5 V max.
(see note 1) (with a flow current of 1 mA max.)
OFF: Open or V
(with a leakage current of 0.1 mA max.)
Remote control output Load power supply voltage:
(see note 1) Load current:
(Residual voltage: 1.2 V max.)
NPN open collector output type
Two banks selectable. Available for remote control only. (Refer to Remote Control Function .)
Bank selection
Circuit protection Protection from reversed power supply connection and load short-circuit
ON: 50 µs max.
Response time
OFF: 70 µs max.
Incandescent lamp: 3,000 lx max.
Ambient illumination
(on receiver lens) Sunlight:
Ambient temperature Operating: –20 C to 55 C/Storage: –30 C to 70 C
(with no icing)
Ambient humidity Operating: 35% to 85%/Storage: 35% to 95 C
(with no condensation)
Insulation resistance 20 MΩ min. (at 500 VDC)
Dielectric strength 1,000 VAC, 50/60Hz, 1 min.
Vibration resistance Destruction: 10 to 55 Hz, 1-mm double amplitude or 150 m/s
(see note 2)
Shock resistance (see Destruction: 500 m/s
note 3)
Degree of protection IEC60529 IP67 (with protective cover)
Connection method Connector
Weight with package Approx. 100 g
box
Material Case:Polybutylene terephthalate
Lens: Acrylic (PMMA)
Others Instruction manual
Note: 1. Remote control input and answer-back output share the same signal line.
2. The Sensor withstands 0.75-mm double amplitude or 100 m/s
3. The Sensor withstands 300 m/s
2
E3M-VG11 E3M-VG21
4 x 1 mm
30 VDC max.
100 mA max.
–1.5 V to V
CC CC
30 VDC max.
100 mA max.
10,000 lx max.
2
3 times each in X, Y, and Z directions
2
if the mounting bracket is attached to the Sensor.
E3M-VG16
1 x 4 mm
Load power supply voltage:
Load current:
(Residual voltage: 2 V max.)
PNP open collector output type
ON: V –1.5 V to V
CC
(with an absorption current of 3 mA max.)
OFF: Open or 1.5 V max.
(with a leakage current of 0.1 mA max.)
Load power supply voltage:
Load current:
(Residual voltage: 2 V max.)
PNP open collector output type
2
for 2 hrs each in X, Y, and Z directions
2
if the mounting bracket is attached to the Sensor.
E3M-V
E3M-VG26
4 x 1 mm
30 VDC max.
100 mA max.
CC
30 VDC max.
100 mA max.