Example 3: Pc To 2 Dcx2496S (Pc<Rs232>1 St Dcx<Rs485>2 Nd Dcx) - Behringer ULTRADRIVE PRO DCX2496 Sync Manual

Example 3: PC to two DCX2496s (PC<RS232>1
1. Connect the first DCX2496 via the RS232 port to the COM port on your computer.
2. Connect the first DCX2496 via its LINK A (or B) port (RS485) to the LINK A (or B)
port (RS485) of the second DCX2496.
3. Push the TERM switch to ON at both DCX2496s.
4. Power up both DCX2496s and the PC.
5. Go to first DCX2496 to SETUP page 6/6 (Miscellaneous)
select "DEVICE ID: 1"
select "PORT: PC -> LINK"
6. Go to second DCX2496 to SETUP page 6/6 (Miscellaneous)
select "DEVICE ID: 2"
select "PORT: LINK (RS485)"
NOTE! All changes you have done on the SETUP page (like new port or
device ID select) will only be stored permanently if you change to another
menu page (e.g. OUT 1) before powering off the DCX2496!
11
12
st nd
DCX<RS485>2 DCX)
17