How To Copy Dcx2496 Data To Another Dcx2496; Example 1: Pc To 1 Dcx2496 Via Rs-232 - Behringer ULTRADRIVE PRO DCX2496 Sync Manual

How to copy DCX2496 data to another DCX2496

- Go to "Connect" Page
- (Click "? Search DCX2496s" only if the devices were not recognized
automatically)
- In the left white field, select the DCX2496 source device (e.g. DCX2496 #1)
Under "Synchronizing," select:
-
o Direction: DCX2496->PC
o All data checkmarks (Current Set / Internal Presets / Card Presets)
Click "Synchronize"
-
Click on the 2
-
- Now select the Direction: PC -> DCX2496
- Click "Synchronize"
- Copying of all data from DCX2496 #1 to DCX2496 #2 is finished
--------------------------

Example 1: PC to 1 DCX2496 via RS-232

1. Connect the DCX2496 via the RS232 port with a standard 9-pin RS232 cable to a
COM port of your computer.
2. Power up the DCX2496 and the PC.
3. Go to DCX2496 > SETUP page 6/6 (Miscellaneous) > select "PORT: PC (RS232)"
NOTE! All changes you have done on the SETUP page (like new port or device ID
select) will only be stored permanently if you change to another menu page (e.g.
OUT 1) before powering off the DCX2496!
4. Launch Remote Editor Software on the PC.
nd
DCX2496 (copying destination) in the left white field
11