Example 2: Pc To 1 Dcx2496 Via Rs-485 - Behringer ULTRADRIVE PRO DCX2496 Sync Manual

Please keep the "Stay Synchronized" box always active!
TIP: In the above screenshot the "DCX2496" has been renamed "My Main DCX #1."

Example 2: PC to 1 DCX2496 via RS-485

1. Connect the DCX2496 via the RS485 port (LINK A or B) with the RS-485 card on
your computer and set the TERM switch on the DCX2496s rear to "on."
2. Power up the DCX2496 and the PC.
3. Go to DCX > SETUP page 6/6 (Miscellaneous) > select "PORT: LINK (RS485)"
NOTE! All changes you have done on the SETUP page (like new port or device ID
select) will only be stored permanently if you change to another menu page (e.g.
OUT 1) before powering off the DCX2496!
4. Launch the Remote Editor Software on the PC.
5. Go to the "Connect" page
14