Other Features - Dimplex DPRC35ECO Instruction Manual

Other features

FOLLOW ME/TEMP SENSING Feature (On some models)
NOTE: This feature can ONLY be activated from the remote control. The remote
control serves as a remote thermostat allowing for the precise temperature
control at its location.
To activate the Follow Me/Temp Sensing Feature, point the remote control
towards the unit and press the Follow Me/Temp Sensing button. The remote
control will send this signal to the air conditioner until the Follow Me/Temp
Sensing button has been pressed again. If the unit does not receive the Follow
Me/Temp Sensing signal during any 7-minute interval, the unit will exit the
Follow Me/Temp Sensing mode.
NOTE: This feature is unavailable under FAN or DRY mode.
AIR FLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. To adjust the air flow direction
automatically:·
When the Power is ON, the louver opens fully. Press the SWING button on the
panel or remote controller to initiate the Auto swing feature. The louvre swings
up and down automatically. Please do not adjust the louver manually.
Wait 3 Minutes Before Resuming Operation.
After the unit has stopped, it cannot restart operation for at least 3 minutes. This
is to protect the unit. Operation will automatically start after 3 minutes.
POWER MANAGEMENT Feature (On some models)
Under cooling operation, when the ambient temperature is lower than the setting
temperature for a period of time, the unit will be automatically turn on the power
management feature. The compressor and fan motor will stop. When the ambient
temperature is higher than the setting temperature, the unit will be automatically turn
off the power management feature. The compressor and (or) fan motor will run.
WATER DRAINAGE
During DRY/dehumidifying mode, remove the drain plug
from the back of the unit, install the drain connector (5/8"
universal female mender) with 3/4" hose (not included).
For the models without drain connector, just attach the
drain hose to the hole. Place the open end of the hose
directly over to a drainage area or bucket.
NOTE: Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain, making sure that there
are no kinks that will stop the warter flowing. Place the
end of the hose into the drain and make sure the end of
the hose is down to let the water flow smoothly. When the
continuous drain hose is not used, ensure that the drain
plug and knob are installed firmly to prevent leakage.
20
15429_Dimplex DPRC35ECO Manual.indd 20 15429_Dimplex DPRC35ECO Manual.indd 20
Remove the
upper drain
plug
Continuous
drain hose
9/09/20 5:51 PM 9/09/20 5:51 PM