Table of Contents
Advertisement
Rea® Clematis® Pro
3.8 Seat
3.8.1 Adjusting the seat width (optional, 2
positions)
1. Remove the armrest holder cap A .
2. Move the armrests sidewards to the desired width into
the armrest holder B.
3. Insert the armrest holder cap A in its new position.
Risk of pinching
Be careful not to trap your fingers between the
armrest side support and the armrest holder.
– Refer to 5.5 Inserting, Removing the Armrests,
page 24.
3.8.2 Adjusting the seat depth
1. Remove the seat cushion.
2. Loosen the screws on the lateral frame A with an 5
mm Allen key C.
3. Move the front edge of the seat forwards or backwards.
4. Re-tighten the screws A (5–6 Nm).
5. Put the seat cushion back.
3.8.3 Adjusting the legrest width
14
1. Loosen the screw on the front frame B with an 5 mm
Allen key C.
2. Move the lateral edge of the legrest sidewards to the
desired position.
3. Re-tighten the screws B (5–6 Nm).
3.8.4 Adjusting the seat cushion
The seat cushion A is secured with hook and loop straps
B on the seat plate.
WARNING!
Risk of seat cushion sliding
– Make sure that the hook and loop straps are
pressed firmly together and make sure that
they stay fixated.
3.9 Leg rests
WARNING!
Risk of injury
– Never lift the wheelchair by the footrest
supports or leg rests.
CAUTION!
Risk of pinching or crushing fingers
There are swing mechanisms where you could
trap your fingers.
– Be careful when using, swinging, disassembling
or adjusting these mechanisms.
IMPORTANT!
Risk of damage to the leg rest mechanism
– Do not place anything heavy, or let children sit
on the leg rest.
3.9.1 Swing away leg rests
1653395-C
Advertisement
Table of Contents
