Invacare Rea Clematis Pro User Manual page 35

1. Attach the snap hooks to the front transportation rings
as shown in the figure above (see location of the
attachment labels).
2. Attach front straps to the rail system referring to best
practice recommended instructions from the safety belt
manufacturer.
3. Disengage parking brakes and apply tension front straps
by pulling the wheelchair backwards from the rear.
4. Re-engage parking brakes.
Rear side tie-down positions for snap hooks:
1653395-C
1. Attach the snap hooks to the rear transportation rings
as shown in the figure above (see location of the
attachment labels).
2. Attach rear straps to the rail system referring to best
practice recommended instructions from the safety belt
manufacturer.
3. Tighten the straps.
IMPORTANT!
– Make sure that the snap hooks are covered
with slip resistant material to avoid laterally
slipping on the axle.
Mounting the Posture Belt
WARNING!
The posture belt could be used in addition to but
never as a substitute for an approved passenger
restraint system (3-point belt).
1. Adjust posture belt to fit the wheelchair occupant, see
section 4.8 Posture belt, page 22.
Transport
35