Installation; With Or Without An Elevator - Graco 25C483 Instructions - Parts Manual

Installation

Installation Installation
Back - - - Gear Gear Mounting Mounting Hole
Back Back Gear Mounting
If using a new drum cover without holes, see below
for hole spacing dimensions.
Assembling and and Positioning
Assembling Assembling and
Agitator
Agitator Agitator
All electrical wiring must be done by a qualified
electrician and comply with all local codes and
regulations. Only trained and qualified personnel
who have read and who understand the information
in this manual should install this equipment.
Always maintain a minimum of 1 in. (25.4 mm)
clearance between rotating agitator parts and
container to prevent sparks from contact.
Personal injury or equipment damage may result
from lifting/falling heavy equipment. To avoid
personal injury or equipment damage:
• Do not lift the drum cover and agitator without
proper assistance
• Do not walk or stand beneath a raised elevator.
3A4548G
Hole Dimensions Dimensions
Hole Dimensions
Positioning the the
Positioning the
With an With With an an Elevator Elevator Elevator
Mount the drum cover as described in manual
Elevators and Pump Supports
306287,
The elevator must be in the down position
when working on the elevator, agitator, or
drum cover assembly (for elevator operating
instructions, see manual 306287,
and Pump Supports ). Proceed to step 1 in
With or Without an Elevator, page 8
Without an an Elevator Elevator
Without Without an Elevator
If your system does not have an elevator, install the
Handles Kit to facilitate handling the drum cover and
To order the Handles Kit, order Part No.
agitator.
237524 .
Place two standard 55 U.S. gallon (45 Imperial gallon)
barrels 14 in. (approximately 36 cm) apart, and center
the drum cover on the barrels with the Graco logo
centered and facing you, as shown in Fig. 1. Proceed
to step 1 in With or Without an Elevator, page 8
Figure 1 Drum Cover on Barrels
Installation
.
Elevators
.
.
7