Reset Button/High Limit Stat; Burner Control Box Lock-Out Reset Button; Hot Water Output Reduction (Dhw Only); Burner Does Not Ignite - Stanley BRANDON Operation Instructions Manual

One of the outstanding features of the Stanley is its
hotplate. It is generous
ground for maximum heat transfer to your cookware.
The temperature of the hotplate is controlled by the
oven control thermostat.
months, when you are busy in the kitchen and you
want warmth from
hotplate, a thermostat setting of 100
the heat you require.
hotter, turn the thermostat up to a higher setting.
The hottest part of the hotplate is at the left side, the
centre is a little cooler and the right side cooler still.
The type of cookware
hotplate's performance.
and hotplate is essential.
On the right there is a small simmering plate.
is ideal for keeping the coffee-pot warm, or you can
keep a kettle of water there ready to move on to the
hotplate. All sorts of culinary jobs can be done over
this gentle heat - dissolving gelatin, melting fats and
chocolate, steaming vegetables, and cooking soups
and stocks.
IMPORTANT : DO NOT ALLOW THE COOKER
BURNER TO RUN WITH THE MAIN OVEN DOOR
OPEN, OTHER THAN
FOOD.

RESET BUTTON/HIGH LIMIT STAT

A high limit thermostat is located behind plinth on
bottom of cooker. Remove plinth by sliding approx
10mm to the left.
The thermostat button will pop out if the temperature
selected is exceeded.
protective cap and press the plastic button inwards.
(See Figs 4, 5, & 6) If this situation persists contact
your Service Engineer.
in size and is
During the cold
the cooker and heat
o
C will give you
If you need the hotplate to be
you use will affect
Good contact between pan
WHEN ATTENDING
T o reset simply unscrew the
PLINTH
Fig.5
machine
winter
in the
the
Fig.6
This
TO
BURNER
BUTTON
The control box reset button, located on the base
underneath the left hand door will illuminate if the
burner experiences a problem.
Press the button to reset the control box.
situation persists, contact your Service Engineer.
(See Fig. 7)
Fig.4

HOT WATER OUTPUT REDUCTION (DHW ONLY)

The requirement
household
provided the temperature in the boiler will reach its
limit temperature and the appliance will shut down
7
CONTROL BOX LOCK-OUT
for hot water
to household. If excess
RESET
If this
Fig.7
PLINTH
differs from
hot water is