Hisense AUD-09HX4SVNL Technical & Service Manual page 102

W I R I N G D I A G
W I R I N G D I A G
1 1 .
1 1 .
OPERATION：
①Hold down both"MODE"button and"ADD.FUNC."button for 3 seconds, symbol
number blinking at the same time.
"" "button to adjust parameter number until display "17".
②Press"
And press "ENTER"button to entering system parameter adaption state, symbol
parameter number blink.
③Select desired parameter code by pressing "
"ENTER" button to confirm.
④Select desired function code by pressing "
Press "ON/OFF"button or "CANCEL"button to quit parameter adaption state.
⑤Press "ON/OFF"button or "CANCEL"button to quit.
PARAMETER PARAMETER
CODE DESCRIPTION
Self Recovery of
1
Power Break
2 Temperature Type
Temperature Display
3
Ratio of ambient
temperature sensed by
4
indoor temperature
sensor(cooling mode)
5 Filter Clean Indication
6 Filter Clean Time Set
Installation Height
7
Compensation
Cooling Temperature
Compensation
8
（indoor unit
temperature sensor）
Heating Temperature
Compensation（indoor
9
unit temperature
10 Static Pressure Set
R A M
R A M
PARAMETER VALUE&REPRESENTATION
DATA
TYPE
Integer
Integer
Integer
Type
Integer
Integer
Integer
Integer
Integer
Integer
sensor）
Integer
"/ " "button following the table below， and press
"/ " "button , and press "ENTER" button to confirm.
REPRESENTATION
(FUNCTION CODE)
0：Cancel Self Recovery of Power Break
function；
1： Set Recovery of Power Break function；
others：invalid
0：Centigrade Temperature；
1：Fahrenheit Temperature；
others：invalid
0：Default display set temperature；
1：Default display room temperature；
others：invalid
0~10valid，more than 10 default is10
0：0%；1：10%；...；10：100%
0：Cancel Filter Clean prompt function；
1：Set Filter Clean prompt function；
others：invalid
0~32，more than 32 default is 32*1000h
0~10m，more than 10m default is 10.
=0,1,2 :no fan speed compensation;
=3: increase fan speed;
=4~10: increase more fan speed.
0：0℃；1：-0.5℃；2：-1℃；3：-1.5℃；
4：-2℃；5：-2.5℃；6：-3℃；7：-3.5℃；
8：-4℃；9：-4.5℃；10：-5℃；
（the wired controller displays integer
with the symbol）
0：0℃；1：-0.5℃；2：-1℃；3：-1.5℃；
4：-2℃；5：-2.5℃；6：-3℃；7：-3.5℃；
8：-4℃；9：-4.5℃；10：-5℃； （the wired
controller displays integer with the
symbol）
function code=static pressure value, the
max. static pressure is different for
different models.Default is
0(default static pressure related to
specific models)
100
and parameter
stop blinking,
NOTE
0:entirely use
temperature sensed
by wired remote
controller; 10:entirely
use temperature
sensed by indoor unit
Only valid for DC
motor cassette
indoor unit
Invalid for single
control board
models
Invalid for single
control board
models
Duct type(DC
motor )