General And Local Standards Information; Risk Guidelines; Vent Pipe Pitch And Supports - Navien NPE-180A2 Installation Manual

General and Local Standards
Information
When installing and operating the common vent
system, the following standards and regulations
must be complied with and adhered to:
Local codes or, in the absence of local codes, the
●
National Fuel Gas Code, ANSI Z223.1/NFPA 54.
Appliance manufacturer's Installation Instructions.
●
Regulations on the supervision of construction.
●
Statutory provisions.
●
Installation and service work must be carried out
●
by licensed professionals only.

Risk Guidelines

Ensure that all common vent system components
●
are manufactured and installed in accordance
with valid standards, regulations, and safety
engineering rules.
To avoid risk, the common vent system must be
●
installed and used only for the original purpose
described in this manual.
Defects or damages found in a common
●
vent system must be addressed and repaired
immediately.
For roof or chimney modifications, refer to the
●
relevant industrial safety regulations.
Works on roofs and facades are dangerous.
●
Comply with all relevant regulations.
Cutting and Assembling Common Vent
System Components
Standard tools are suitable for the cutting and
assembly of common vent system components.
Follow the guidelines listed below when working
with the components.
When cutting vent components, ensure that the
●
cuts are straight. Chamfer and deburr all edges
before installing the components.
All vent joints must be fully tightened.
●
Before operating the system, ensure that the
●
Installed vent system is clean and free of debris.
Ensure that the vent system is rigidly supported
●
according to the manual's instructions.
Selecting Vent Pipe Materials
Consult the following chart or the most recent edition
of ANSI Z223.1/NFPA 54, as well as all applicable
local codes and regulations when selecting vent
pipe materials. This appliance should be vented with
materials approved for Category IV gas appliances. Do
not use cellular core PVC (ASTM F891), cellular core
CPVC, or Radel® (polyphenylsulfone) for the exhaust
vent. See below for recommended vent materials.
Locale Recommended Vent Materials
PVC Schedule 40 (Solid Core)
●
CPVC Schedule 40 or 80 (Solid Core)
●
UL1738 approved PVC or CPVC
●
USA
Centrotherm Innoflue
●
Polypropylene
Approved Stainless Steel
●
ULC-S636 Type BH Special Gas Vent
Class IIA (PVC)
●
Class IIB (CPVC)
●
Canada
Class IIC (Centrotherm Innoflue/
●
Approved Stainless Steel)
(Refer to page 51.)

Vent Pipe Pitch and Supports

For horizontal runs, slope the horizontal section
upward toward the vent termination at a rate of 1/4"
per foot (2% slope).
Connecting Pipes with Cement
WARNING
Do not mix components from different systems.
The vent system may fail and harmful flue
products may leak into the living space. Mixing
of venting materials will void the warranty and
certification of the appliance.
CAUTION
The vapors from primers and solvent cements
can cause nausea and continuous exposure is
dangerous to your health. Ensure that the work
area is well ventilated, or wear an approved
organic vapor respirator when working with
primers and solvent cements.
Installing a Common Vent System 67