Adding Printers In Netware - Axis 5400+ User Manual

Adding Printers in NetWare

Section 6 Adding Printers in NetWare
42
This section describes how to continue the installation of the AXIS
5400+/AXIS 5600+ in the NetWare environment. Identify which transport
protocol you are running on your network and which installation method
you should use. Continue the installation by selecting the appropriate
installing instructions from the table below:
Installation Transport
method protocol
TCP/IP
NDPS
IPX/SPX
iPrint over LPR
iPrint
iPrint over IPP
IPX/SPX
Basic
Configuration
Queue-based
printing
IPX/SPX
Advanced
configuration
See "NetWare Administration" on page 66 for information on Novell's
administration tools.
If you intend to operate your AXIS 5400+/AXIS 5600+ in a multi-
protocol, mixed environment, you should also proceed to the other
relevant sections in this manual.
Action
See "Setup using NDPS" on page 43 and
"Public Access Printers" on page 44
"Controlled Access Printers" on page 48
See "Setup using iPrint" on page 57 and
"Install a printer using AXIS LPR Gateway Configuration Snap-in"
on page 59
See "Setup using iPrint" on page 57 and
"Install a printer with AXIS IPP Gateway Configuration Snap-in"
on page 59
To install using the AXIS NetPilot Installation Wizard,
see "Basic Setup with AXIS NetPilot" on page 61
If you need a more advanced installation that is not covered by
the AXIS NetPilot Installation Wizard, see
"Advanced Installation using AXIS NetPilot" on page 62
AXIS 5400+ / AXIS 5600+ User's Manual