Section 6 Adding Printers In Netware - Axis 5900 User Manual

Adding Printers in NetWare
Section 6 Adding Printers in NetWare
50
This section describes how to continue the installation of the AXIS 5900
in the NetWare environment. Identify which transport protocol you are
running on your network and which installation method you should use.
Continue the installation by selecting the appropriate installing
instructions from the table below:
Installation Transport
method protocol
TCP/IP
NDPS
IPX/SPX
iPrint over LPR
iPrint
iPrint over IPP
IPX/SPX
Basic
Configuration
Queue-based
printing
IPX/SPX
Advanced
configuration
See "NetWare Administration" on page 76 for information on Novell's
administration tools.
If you intend to operate your AXIS 5900 in a multi-protocol, mixed
environment, you should also proceed to the other relevant sections in
this manual.
Action
See "Setup using NDPS" on page 51 and
"Public Access Printers" on page 52
"Controlled Access Printers" on page 55
See "Setup using iPrint" on page 67 and
"Install a Printer using AXIS LPR Gateway Configuration Snap-in"
on page 69
See "Setup using iPrint" on page 67 and
"Install a Printer with AXIS IPP Gateway Configuration Snap-in"
on page 68
To install using the AXIS NetPilot Installation Wizard,
see "Basic Setup with AXIS NetPilot" on page 71
If you need a more advanced installation that is not covered by
the AXIS NetPilot Installation Wizard, see
"Advanced Installation using AXIS NetPilot" on page 72
AXIS 5900 User's Manual