Adding Printers In Windows Nt4 Using The Microsoft Lpr Monitor; Adding Printers In W2K/Xp Using The Microsoft Lpr Monitor - Axis OfficeBasic USB Wireless User Manual

Adding Printers in Windows NT4 Using the Microsoft LPR Monitor

Preparing for
LPR Printing
Installing a Network
Printer
Adding Printers in Windows 2000/Windows XP Using the Microsoft LPR Monitor
Basic Setup
AXIS OfficeBasic USB Wireless
In the Control Panel, double-click the Network icon. Select the Services tab. If
the TCP/IP Printing entry appears, then TCP/IP is already installed. Close the
Network folder and go on to Installing an LPR printer, below.
First, prepare for LPR printing:
1. Open the Control Panel and double-click the Network icon.
2. Select Protocols.
3. Add TCP\IP Protocol.
4. Select Services.
5. Add Microsoft TCP\IP Printing.
1. Make sure your print server has a valid IP address, see IP Addressing, on
page 10.
2. Select My Computer and click Next.
3. From the Available Ports list, click Add Port.
4. Choose LPR Port and click New Port.
5. Type the name of your AXIS OfficeBasic USB Wireless or IP address in the
Name or address of server providing lpr field (Example: 192.168.3.191). Then
enter which port to use in the Name of printer or print queue on that server
field (Example: usb or lp1). Click OK then Close.
6. The added print server will now appear in the Available Ports list. Click Next,
choose a driver and finish the installation as usual.
This section describes how to set up a Windows 2000/XP server for LPR
printing, using the built-in Microsoft LPR Monitor, Print Services for UNIX.
If you have not already done so, you should perform the TCP/IP basic setup
procedures prior to installing a printer for LPR printing.
Windows Setup
23