BMW R 1200 R 2008 Rider's Manual page 40

signal until after this speed has
3
been exceeded for the first time
( 81).
38
Watch TPC display at higher
speed. A permanent fault has
not occurred until the general
warning light also lights up. In
this case:
Have fault eliminated by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
There is a fault in the radio con-
nection to the TPC sensors.
z
Possible causes are radio sys-
tems in the surrounding area,
which interfere with the connec-
tion between the TPC control
unit and the sensors.
Watch the TPC display in an-
other environment. A perma-
nent fault has not occurred un-
til the general warning light also
lights up. In this case:
Have fault eliminated by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Sensor defective or
system fault
General warning light shows
yellow.
Warning triangle appears on
the display.
" " or " " is displayed.
-- -- --
Possible cause:
Wheels without installed TPC
sensors are mounted.
Retrofit wheel set with TPC
sensors.
Possible cause:
One or two TPC sensors have
failed.
Have fault eliminated by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
A system fault has occurred.
Have fault eliminated by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Battery of tire pressure
sensor weak
General warning light shows
yellow.
Warning triangle appears on
the display.
appears on the display.
RdC
This error message is only
displayed for a short time
following the pre-ride check.