Figure 3.10: Oscar Interface Keyboard Dialog Box - Avocent DSR Series DSR1010 Installer/User Manual

Sun servers may use keyboard mappings for non-US keyboards. By default, the DSR switch sends
the US keyboard country code to Sun and USB modules attached to target devices, and the code is
applied to the target devices when they are powered up or rebooted. Codes are then stored in the
IQ module.
Issues may arise when you use the US keyboard country code with a keyboard of another country.
For example, the key on a US keyboard is in the same location as the
Z
keyboard. Sun servers will interpret pressing the
when the US keyboard country code is used.
The Keyboard dialog box enables you to send a different keyboard country code than the default
US setting. The specified country code is sent to all target devices attached to the DSR switches
when they are powered up or rebooted, and the new code is stored in the IQ module.
NOTE: If an IQ module is moved to a different target device, the keyboard country code will need to be reset.
See Sun Advanced Key Emulation on page 117 for information on emulating certain Sun keys using
a PS/2 keyboard and special considerations for Japanese and Korean Sun USB keyboards.
NOTE: Only local users can view or change keyboard country code settings.
To set the keyboard country code for Sun servers:
1. If the OSCAR interface is not open, press
2. Click Setup - Keyboard to open the Keyboard dialog box shown in Figure 3.10.

Figure 3.10: OSCAR Interface Keyboard Dialog Box

3. Select a country code and click OK to save your settings.
4. Reboot the Sun servers. After rebooting, each Sun server will request the country code setting
stored in the IQ module.
Chapter 3: Local Port Operation
key on a German keyboard as pressing the
Y
to open the Main dialog box.
Print Screen
key on a German
Y
Z
29
key