Setting Local Port Screen Saver Options - Avocent DSR Series DSR1010 Installer/User Manual

To add a target device within an existing list, place your cursor in the line below where you
want to insert a new target device and press
4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
a. Press
b. Press
c. Press
d. Press
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
6. Move the cursor to the next line or press
remaining target devices to be included in the scan pattern.
7. Click OK to save your settings.
To remove a target device from the Scan list:
1. In the Scan dialog box, click the target device to be removed.
2. Press
Delete
-or-
Press
Shift+Delete
3. Click OK to save your settings.
For more on starting and stopping scanning, see Enabling or disabling Scan mode on page 36.

Setting local port Screen Saver options

You can use the Screen Saver dialog box to manage the screen saver inactivity time and test the
Screen Saver mode on the local port. If OSCAR Authentication has been enabled, after the
specified Inactivity Time elapses, the local port locks and remains locked until you press any key or
move the mouse. You will then need to log in and reselect a target device to continue.
To access the OSCAR interface Screen Saver dialog box:
1. If the OSCAR interface is not open, press
2. Click Setup - Screen Saver to open the Screen Saver dialog box shown in Figure 3.9.
to move the cursor down through the list of target devices.
Alt+Down Arrow
to move the cursor up through the list of target devices.
Alt+Up Arrow
to move the cursor to the first target device in the list.
Alt+Home
to move the cursor to the last target device in the list.
Alt+End
.
to remove the selected target device and all entries below it.
Chapter 3: Local Port Operation
.
Insert
and repeat steps 2-5 for each of the
Down Arrow
Print Screen to open the Main dialog box.
27