AT&T Merlin Plus User Manual page 26

2 Wait for an answer.
Dial * followed immediately by your authorized caller code and # #.
3
The two-beep confirmation tone sounds.
4
Dial *8.
5 Dial the route number (0
6 Dial the extension code.
7 Dial the transfer code.
Dial the extension number where the caller will be connected.
8
Dial # # # #.
9
The two-beep confirmation tone sounds.
10 Continue programming or exit authorized caller mode by dialing * # #.
To disconnect, dial # #.
11
Erasing an Existing Route
If you need to eliminate a route you previously programmed, follow the
procedure below:
1 Select an outside line and dial a telephone number that is answered by
your MERLIN Attendant.
If you are programming from a remote location using a single-line
NOTE:
standard Touch-Tone phone, enter only one pound sign ( # ) for
every two pound signs ( # # ) that appear in a programming
command.
Wait for an answer.
2
3
Dial * followed immediately by your authorized caller code and # #.
The two-beep confirmation tone sounds.
4 Dial *8.
5 Dial the route number (0 through 9) you want to erase.
Dial the extension code of the route you want to erase.
6
7 Dial 0, the transfer code for "No Operation."
8 Dial ####.
The two-beep confirmation tone sounds.
9 Continue progr amming or exit authorized caller mode by dialing * # #.
10 To disconnect, dial # #.
through 9).
=
11 Day Primary Extension
=
21 Night Primary Extension
2 = Blind Transfer
=
5 Disconnect
11 =
Day Primary Extension
21 = Night Primary Extension
Changing the Current Settings
2-11