AT&T Merlin Plus User Manual page 16

Changing the Current Settings
CONFIRMATION
AND ERROR TONES
ON-SITE PROGRAMMING
REMOTE PROGRAMMING
You may need to change one or more of the current settings for the
MERLIN Attendant if, for example, your business hours change or you need
to reset the clock for daylight saving time. On-site changes can be made only
from a multi-line MERLIN system telephone. Changes can also be made from
a remote location using a standard Touch-Tone telephone.
If you have more than one MERLIN Attendant in your MERLIN Plus system,
all their settings must be exactly the same. You must change settings on all
MERLIN Attendants whenever you change the settings on one.
When you program a feature correctly, you hear a two-beep confirmation
tone. You hear a three-beep error tone if you enter a command incorrectly.
All on-site programming for the MERLIN Attendant must be done from a
multi-line MERLIN Plus system telephone that is connected to the
MERLIN Plus system control unit.
Several of the programming sequences use two or more pound signs
NOTE:
(## ) in some steps of the programming procedure. Because the
MERLIN Plus system uses the pound sign (#) to activate system
features, you will not hear a tone when you enter the first and third
pound signs in any programming sequence.
All off-site programming must be done from a standard single-line
Touch-Tone phone that is not connected to the MERLIN Plus system.
Procedures for remote programming are slightly different than on-site
programming procedures. When programming remotely, you must enter
only one pound sign (#) for every two pound signs (# # ) appearing in any
programming command.
When programming from a remote location using a standard Touch-Tone
telephone, dial # if the procedure says, "Dial # #." Similarly, dial # # if the
procedure says, "Dial # # # #."
Changing the Current Settings 2-1