AT&T Merlin Plus User Manual page 22

RESETTING THE CLOCK
FOR DAYLIGHT SAVING
TIME
CHANGING YOUR
RECORDED
ANNOUNCEMENTS
To adjust the MERLIN Attendant's clock by one hour (for daylight saving
time), use the following instructions.
1 Select an outside line and dial a telephone number that is answered by
your MERLIN Attendant.
If you are programming from a remote location using a single-line
NOTE:
standard Touch-Tone phone, enter only one pound sign (#) for
every two pound signs ( # # ) that appear in a programming
command.
2 Wait for an answer.
3 Dial * followed immediately by your authorized caller code and # #.
The two-beep confirmation tone sounds.
4 Dial *72.
5 Perform the appropriate procedure:
Dial 1 to add one hour to the current time (normally used in the spring
to begin daylight saving time).
Dial 2 to subtract one hour from the current time (normally used in the
fall to cancel daylight saving time).
The two-beep confirmation tone sounds.
6 Continue programming or exit authorized caller mode by dialing * # #.
If you have more than one MERLIN Attendant, you may transfer
NOTE:
to each one by dialing the intercom numbers assigned to them—
usually 11, 12, and 13. Follow the procedures in this section to
program every MERLIN Attendant identically.
7 To disconnect, dial # #.
Three types of recorded announcements are available with the
MERLIN Attendant: Day, Night, and Hold.
The total duration for all recorded announcements for the MERLIN Attendant
must equal 64 seconds. Each recorded announcement has a maximum duration
in seconds as follows:
TABLE 2-2 Time Allocations for Recorded Announcements
Duration
(Seconds)
Announcement
25
Day
25
Night
Hold 14
Total 64
Changing the Current Settings 2-7