Lucent Technologies Definity Callmaster II Programming The Options page 7

5 When the setting you prefer is shown on the display, press [
save it and exit programming mode.
NOTE: No recorder warning tones will be produced when the Record
Out Signal is disabled regardless of the setting of these tones.
SETTING THE HEADSET VOLUME CONTROL
The following options are available for setting the headset volume:
Per Plug — Adjust the headset volume with the Volume control
button on the voice terminal. The volume is automatically set to
the nominal (middle) setting when the headset is first plugged in.
Changes in the volume setting are retained from call to call.
Per Call — Adjust the headset volume with the Volume control
button on the voice terminal. However, the headset volume is
automatically reset to the nominal (middle) setting for each new
call.
NOTE: For Per Call operation, the station must be administered
as a CALLMASTER.
Disabled — The headset volume is fixed at nominal (middle),
and the Volume button on the voice terminal affects only ringer
volume (not headset volume).
To change the headset volume control
1 While on-hook (the headset must be unplugged), press [
The light next to [
2 Press [ ].
Mute
The CALLMASTER set is in option programming mode.
3 Dial the 2-digit code, "48" ("HV").
The current setting (Per Plug, Per Call, or Disabled) is
shown on the display.
4 Dial [ ] to change the setting.
*
5 When the setting you prefer is shown on the display, press [
save it and exit programming mode.
] goes on.
Select
5
] to
#
].
Select
] to
#