Figure 131. Removing the power button control panel for Front Accessed configuration
Next steps
Installing the power button control
Installing the power button control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card riser
4.
Remove the air
shroud.
5.
Remove the expansion card riser
Steps
1. Route the control panel cable through the side wall of the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the control panel in the slot on the system.
3. Connect the control panel cable to the connector on the system board.
4. Using the Torx #8, tighten screws from power button control panel assembly.
5. Using the Phillips #2, tighten screws from rack ear assembly.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
panel.
Safety
instructions.
Before working inside your
2.
1.
system.
Installing and removing system components
117