Hydraulic Functions - Jacuzzi cloud Use & Maintenance

hydraulic functions

Water does not exit (shower head, waterfall, hand held shower, etc.).
- Check that the water supply has not been cut-off.
- Open the stop tap.
- Make sure the diverter is positioned towards the symbol of the function you want
to use.
- In the case of electronic functions, make sure that the diverter is positioned towards
the "E" symbol and that the tap is open (refer to the "Electronic activation of the water
jet functions" chapter).
Insufficient shower pressure.
Clean the shower filter (refer to the "Routine maintenance" chapter).
Not much water exits in all functions.
Check that the water flow rate/pressure conditions indicated on the pre-installation
sheet have been respected. In the case of "hard" or impure water, or after the shower
unit has been used for a long time, it may be necessary to clean the solenoid valve
and/or mixer valve filters (contact a Jacuzzi® Service Centre).
Difficulty in regulating the water temperature (mixer).
Have checked that the network pressure values (when used) between hot and cold
water are balanced (con
51