Troubleshooting; Camera Is Not Turning On; Pir Sensor Fails To Trigger Alarm; Failed To Reset The Camera - Uniden App Cam Solo 4G PT Quick Start Manual

Troubleshooting

Camera is not turning on

If your camera is not turning on, please apply the following solutions:
• Make sure you've turned the power button on.
• Charge the camera with a DC 5V/2A power adapter. When the green light is on, the battery is fully
charged.

PIR sensor fails to trigger alarm

If the PIR sensor fails to trigger any kind of alarm within the covered area,please apply the following
solutions:
• On Uniden Solo App and go to Device Settings-> PIR Settings. Check if the Time Schedule,
Sensitivity and Action settings are enabled and set properly.
• Adjust the camera angle so as to improve its motion detection performance.
• Reset the camera and see if it works.

Failed to reset the camera

Please strictly follow the steps below in order to reset the camera successfully:
• If the camera has already powered on for a long time, please use the reset needle to press
the reset button for about 3 seconds. After hearing a prompt tone/sound, release the reset
button.
• If the camera just starts up, please wait for about 20 seconds. After you see a flashing blue or red
LED, use the reset needle to press the reset button.
17