Omega i Series User Manual page 28

ENTERING OR CHANGING YOUR (DEFAULT) ID CODE:
Press d
Press d
If you want to change your default "ID Code" you can do it now, otherwise
press a and menu will skip to FULL Full Security Submenu.
Press b & c 12) Press b and c buttons to enter your new "ID Code" number.
Press d
FULL SECURITY LEVEL SUBMENU:
Press d
Press b
Press d
If "Full" Security Level is "Enabled" and the user attempts to enter the
Main Menu, they will be prompted for an ID Code. The ID Code should
be correct to enter the instrument Menu item.
SETPOINT/ID SECURITY LEVEL SUBMENU:
Press d
Press b
Press d
If "Setpoint/ID" Security Level is "Enabled" and the user attempts to advance
into the CNFG Configuration Menu, he will be prompted for ID Code number.
The ID Code should be correct to proceed into the Configuration Menu,
otherwise display will show an Error and skip to the Run Mode.
If "Full" and "Setpoint/ID" Security Levels are "Disabled", the ID code will be
"Disabled" and user will not be asked for ID Code to enter the Menu items ("ID"
Submenu will not show up in "ID/Setpoint" Menu).
Enter ID menu (Repeat steps from 1 to 3).
10) Display advances to CH.ID Change ID Code Submenu.
11) Display shows 0000 message with flashing 1
13) Display shows STRD stored message momentarily and then
advances to the FULL Full Security Submenu.
14) Display flashes ENBL Enable or DSBL Disable.
15) Scroll through the available selections: "Enable" or "Disable".
16) Display shows STRD stored message momentarily and then
advances to SP.ID Setpoint/ID Submenu.
This Security Level can be functional only if FULL Security Level
is Disabled.
17) Display flashes ENBL Enable or DSBL Disable.
18) Scroll through the available selections: "Enable" or "Disable".
19) Display shows STRD stored message momentarily and then
advances to COMM Communication Submenu.
24
st
digit.