Omega i Series User Manual page 24

ALARM ENABLE/DISABLE AT POWER ON:
Press d
Press d
If Alarm at Power On is enabled, the alarm will be active when an alarm
condition occurs.
If Alarm at Power On is disabled, the alarm will not be active (even if an
alarm condition exists) unless the process value moves into a non-alarm
condition and back into an alarm condition.
ALARM 1 LOW VALUE SUBMENU:
Press d
Press b & c 16) Use b and c to enter Alarm 1 Low Value.
Press d
ALARM 1 HI VALUE SUBMENU:
Press d
Press b & c 19) Use b and c to enter Alarm1 Hi Value.
Press d
13) Display flashes previous selection. Press b to ENBL enable
or DSBL disable.
14) Display shows STRD stored message. momentarily (only if it
was changed) and then advances to ALR.L .
15) Display flashes 1
enter new value.
17) Display shows STRD storage message momentarily (only if
it was changed) and then advances to ALR.H .
18) Display flashes 1
enter new value.
20) Display shows STRD stored message momentarily (only if it
was changed) and then advances to the next menu.
st
digit of previous value. Use b and c to
st
digit of previous value. Use b and c to
20