Harman Stove Company DVC500-C Manual page 24

Fig. 29
Grate System Assembly Or Replacement:
of four pieces: the grate holder, 63 hole
grate inserts, and grate angle. The grate
angle is bolted to the grate holder with (2)
3/8 x 1 1/4 bolts. Before installing the grate
Fig.30
holder, 3/8" round gasket must be checked in
the groove on the bottom side of the grate
holder, as shown in Fig 31. Check to be sure
the gasket has not been damaged.
through the top door opening after the feeder
has been installed.
grate holder into the slot on the feeder as
shown below. Bolt the front end down with
Fig.31
the 1/4 x 20 allen bolt and nut provided. The
rear end will be locked in place by the
flange. Before tightening the bolt, be sure the
grate holder is back as far as possible and
centered side to side on the feeder opening.
Seal joints with high temp furnace cement
caulking as shown in Fig 30. Insert first
grate and squeeze into caulking. Caulk other
grate insert, Fig 29, on edge that joins grate
already in place. Insert caulked grate in
remaining space and squeeze together to
make middle joint as tight as possible. Clean
any caulking that has pushed out from the
Fig.32
joints on top of grates. Let caulking cure
before firing.
Install firebricks
as shown
The DVC500 grate system is composed
The grate holder must be installed
Locate the flange at the rear of the
Install grate inserts as shown at left.
Fig.33
24