FIGURE 10-a
Using a pair of needle-nosed pliers, snip the joint pictured
in the diagram and remove it.
FIGURE 17-b
Be sure to route the flat cable of the LCD unit as shown for
connection to its connector.
LASER CLASS 730i/720i/710 5.GUIDE TO REPLACEMENT
See Page
FIGURE 17-a
2-19
Cover 1
Open one-touch dial cover 1, remove the claw, and take off
the cover. Bend one-touch dial covers 2 and 3 as shown by
the arrows and remove them.
See Page
FIGURE 19-a
2-33
Feed the sensor board cable and grounding wire through
the groove in the right side of the shaft as shown in the
diagram.
5-2
manuals4you.com
manuals4you.com
See Page
2-33
Cover 2
Cover 3
See Page
2-37