LASER CLASS 730i/720i/710 Chapter 5: Appendix
(7) Keep the three clamps open.
(8) Connect the 6-pin cable to the connector J101 of the dual-line unit; connect the 14-pin
cable to the connector J104; then, connect the flat cable to the connector J102. Be sure
that the side with the shorter bend of the flat cable is connected to the connector J102
Clamp
Connector J102
Connector J101
Figure 5-65 Preparation for Installation 5
Connector J104
Short bend
(to Connector J102)
5-58
manuals4you.com
manuals4you.com
Clamps