Canon LASER CLASS 730i Service Manual page 283

c) Execute an All Clear
After ROM replacement and Printer Kit III installation, carry out "All Clear" by the steps
below.
Data Registration
Display ALL by
Set
pressing
#12 CLEAR
CLEAR OK
While waiting to return to the ready state after executing "All clear", please
do not press the stop button. Doing so may cause a malfunction afterwards.
d) Data Re-registration
Check the lists outputted before ROM replacement, and register the data again if
necessary.
LASER CLASS 730i/720i/710 Chapter 5: Appendix
Display #12 CLEAR by
#
pressing or
or button
PLEASE WAIT
Figure 5-85 All Clear Operation
5-75
SERVICE MODE
#12 CLEAR
button
#12 CLEAR
ALL
Standby
Set