Introduction - Mitsubishi Electric NZ2GN2S1-16D User Manual

INTRODUCTION

Thank you for purchasing the CC-Link IE TSN remote I/O module and the waterproof/dustproof remote I/O module (hereafter
referred to as I/O module).
This manual describes the procedures, system configuration, parameter settings, functions, and troubleshooting required to
use the following modules in CC-Link IE TSN communication mode.
Before using this product, please read this manual and the relevant manuals carefully and develop familiarity with the
functions and performance of the I/O module to handle the product correctly.
When applying the program examples introduced in this manual to an actual system, ensure the applicability and confirm that
it will not cause system control problems.
CC-Link IE TSN communication mode
When using the I/O module as a remote station on CC-Link IE TSN, select CC-Link IE TSN communication mode.
To operate the I/O module in CC-Link IE TSN communication mode, set the function setting switch 1 to OFF. ( Page 120
Function setting switch setting)
Relevant products
NZ2GN2S1-16D, NZ2GN2S1-32D, NZ2GN2B1-16D, NZ2GN2B1-32D, NZ2GNCF1-32D, NZ2GNCE3-32D, NZ2GN12A4-
16D, NZ2GN12A4-16DE, NZ2GN2S1-16T, NZ2GN2S1-32T, NZ2GN2B1-16T, NZ2GN2B1-32T, NZ2GNCF1-32T,
NZ2GN2S1-16TE, NZ2GN2S1-32TE, NZ2GN2B1-16TE, NZ2GN2B1-32TE, NZ2GN12A2-16T, NZ2GN12A2-16TE,
NZ2GN2S1-32DT, NZ2GN2B1-32DT, NZ2GNCE3-32DT, NZ2GN2S1-32DTE, NZ2GN2B1-32DTE, NZ2GN12A42-16DT,
NZ2GN12A42-16DTE
Unless otherwise specified, this manual describes the program examples in which the remote I/O signals and
remote registers are assigned for an I/O module as follows.
• Remote input signals: RX0 to RX1F
• Remote output signals: RY0 to RY1F
• Remote register: RWr0 to RWr8F
• Remote register: RWw0 to RWw8F
For the assignment of remote I/O signals and remote registers, refer to the following.
Page 185 Program Example
6