Chapter 3:
This chapter provides the installation procedure for LightField
the IsoPlane 81.
3.1
Prerequisites
Before beginning to install LightField for the IsoPlane 81, verify that:
3.2
Installation Procedure
Perform the following procedure to install LightField for the IsoPlane 81 on the host
computer:
1.
2. Double-click on LightField Install.exe to start the software installation. Follow the
3. After the installation has been completed, reboot the host computer. A shortcut to
4. Connect the IsoPlane 81 system to the host computer with the USB 3 cable. Apply
5. Before starting the software, make sure the license dongle is inserted into a USB
6. Launch LightField and begin experiment configuration. If installation is successful
Installation of LightField for
the IsoPlane 81
•
The operating system on the desired host computer is either Microsoft
®
Windows
8 (64-bit) or Microsoft Windows 10 (64-bit);
•
You have a LightField license USB dongle;
•
The host computer supports USB 3;
If it does not support USB 3, refer to the host computer manufacturer's
instructions for installing a USB 3 interface card;
•
The host computer is connected to the Internet. An Internet connection is
required for product activation.
Use the LightField Installation CD or download the latest LightField software from
TPI's public FTP site:
ftp://ftp.princetoninstruments.com/Public/Software/Official/LightField.
on-screen prompts to finish
LightField can be found on the desktop.
power and turn on the IsoPlane 81 spectrometer.
port on the host computer.
and the IsoPlane 81 system is correctly connected, then an instrument icon will be
displayed under Device panel.
®
application software for
®
19