Table of Contents
Advertisement
24
en | Installation
3.6
Attach Camera to Junction Box
The bottom hinge pin of the camera arm has a stop to hold the
hinge open while attaching the arm to the junction box.
DANGER!
Serious injury or death can occur if the hinge pins of the
camera arm are not fully engaged (locked) to the junction
box. Use caution before releasing the camera arm.
1.
Figure 3.6 Camera Box Hinge Alignment
2.
NOTICE!
Both hinge pins must be fully compressed to open (unlock)
the hinges of the camera arm and before proceeding to step
3.
3.
4.
AM18-Q0663 | 1.0 | 2013.09
www.a1securitycameras.com email: sales@a1securitycameras.com
Compress the bottom hinge pin by pushing the pin lever
downward and rotating it behind the hinge pin stop.
Open the top hinge by pushing and holding up the pin
lever.
While continuing to hold the top hinge pin, open and align
the top and bottom hinges of the camera arm to their
mating points on the junction box.
Once you have aligned the hinges, release the top hinge
pin to engage its mating hinge on the junction box, and
Installation manual
Available from A1 Security Cameras
DINION imager 9000 HD
Bosch Security Systems
Advertisement
Table of Contents
