Panasonic S-80MW1E5 Service Manual & Test Run Service Manual page 36

2. Detailed Settings Function
Detailed Setting Items
Item code
10 Unit type
11 Indoor unit capacity
System (outdoor unit)
12
address
13 Indoor unit address
14 Group address
Automatic stop time after
18
operation start
OFF reminder function for
35
weekly timer
Cooling temperature setting
Remote controller temperature setting
Heating temperature setting
5
Item
Set when the indoor unit EEPROM memory is replaced during servicing.
These are not set at the time of shipping from the factory.
These must be set after installation if automatic address setting is not
performed.
The time at which an indoor unit is automatically stopped after operation starts
can be set in increments of 5 minutes.
This setting switches the operation when the weekly timer is
connected to the remote controller.
This can be used to prevent cases in which the unit is accidentally left ON.
There is no change when this setting is ON, however it is necessary to set the
weekly timer ON time.
Shift temperature
Shift temperature
Description
(+)
(–)
5 - 6
Air-to-Water Indoor Unit