Table of Contents
Advertisement
To wire the power supply:
1.
2.
3.
4.
5.
SECTION A–A
Figure 7.
Securing the HDMI Connector Using the LockIt Cable Lacing Bracket
After connecting an input or output device to
an HDMI connector, secure the connector in
place with the provided LockIt bracket as
follows:
1.
2.
3.
4.
5.
Cut the DC output cord to the length needed.
Strip the jacket to expose 3/16 inches (5 mm) of the conductors.
Slide the leads into the supplied 2-pole captive screw plug, and use a small screwdriver
to secure them.
To verify the power cord polarity before connecting the plug, connect the power supply
with no load and check the output with a voltmeter.
Use the supplied tie wrap to strap the power cord to the extended tail of the connector.
A
Smooth
Ridges
3/16"
A
(5 mm) Max.
Wiring the Power Connector
Plug the HDMI cable into the panel
connection (
).
1
Loosen the HDMI connection mounting
screw from the panel enough to allow the
LockIt lacing bracket to be placed over
it (
).
2
Place the LockIt lacing bracket onto the
screw and slide it up against the HDMI
connector. Tighten the screw to secure the
bracket (
).
3
ATTENTION:
•
Do not overtighten the HDMI
connector mounting screw.
The shield it fastens to is
very thin and can easily be
stripped.
•
Ne serrez pas trop la vis
de montage du connecteur
HDMI. Le blindage auquel
elle est attachée est très fin et
peut facilement être dénudé.
Loosely place the included tie wrap around the HDMI connector and LockIt lacing
bracket (
).
4
While holding the connector securely against the lacing bracket, tighten the tie wrap,
then remove any excess length.
POWER
12 V
1.5 A MAX
1 1 1
3 3 3
DSC 401 and DSC 401 A User Guide • Installation
2 2 2
4 4 4
3
11
Advertisement
Table of Contents
