Securing The Hdmi Connectors Using The Lockit Hdmi Lacing Brackets; Connecting For Remote Control; Connecting To The Rs-232 Port - Extron electronics mediaport 200 User Manual

Securing the HDMI Connectors Using the LockIt HDMI Lacing Brackets

After connecting an input or output device to an HDMI
connector, secure the connector in place with the
provided LockIt bracket (see the illustration at right):
1.
2.
3.
4.
5.

Connecting for Remote Control

The MediaPort 200 has three ports through which it can be connected to a computer for
configuration and control: the rear panel RS-232 port, the rear panel Ethernet LAN port, and
the front panel USB Config port.

Connecting to the RS-232 Port

To connect the computer or control system to the MediaPort RS-232 port, use an Extron
Universal Control cable (UC50' or UC100') or other female 9-pin-to-bare-wire RS-232 cable.
1.
Plug one or both HDMI cables into the panel
connection ( ).
2
Loosen the HDMI connection mounting screw
from the panel enough to allow the LockIt lacing
bracket to be placed over it (
Place the LockIt lacing bracket onto the screw and slide
it up against the HDMI connectors. Tighten the screw to
secure the bracket ( ).
3
ATTENTION:
• Do not overtighten the HDMI connector mounting screw. The shield to which it
fastens is very thin and can easily be stripped.
• Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
Loosely place the included tie wrap around the HDMI connectors and the bracket (
While holding the connector securely against the lacing bracket, tighten the tie wrap,
then remove any excess length.
Wire the unterminated end of the RS-232 cable to the provided 3-pole captive screw
connector as shown in figure 9:
RS-232
MediaPort 200 Rear Panel
RS-232 Port
Tx Rx G
1 2 3
NOTES:
• If you use cable that has a drain wire, tie
the drain wire to ground at both ends.
• Connect a ground wire between the
MediaPort and the computer.
Ground (G)
Receive (Rx)
Transmit (Tx)
Figure 9. Connecting to the RS-232 Port
3 3 3
).
2
Transmit (Tx)
Receive (Rx)
Computer
RS-232 Port
MediaPort 200 • Installation
1 1 1
2 2 2
5 5 5
4 4 4
).
4
11