Table of Contents
Advertisement
ANTENNA AND SPEAKER CONNCTIONS
① Antenna connection SO-239
② The DATA port is for connection to an external TNC. It is not used in our setup, but could be
used with a Signalink or similar device for sound-card-based data modes. It is a 6-pin DIN
connector with the standard pinout used by most major manufacturers.
③ The PC port is used only for programing the radio using a Kenwood PG-5G serial cable or
compatible USB programming cable. Use the COM port on the Operation Panel to connect a
laptop for packet-based data modes such as Winlink using the radio's built-in TNC. (See
following page.)
④ External speaker connections. 3.5 mm mono jacks. A single external speaker (or
headphones) plugged into SP 1 mutes the built-in speaker and provides both Band 1 and Band 2
audio on the external speaker.
ear, unless you use an adapter. We don't use SP 2 in our setup.
1
Check Menu Item 002 if both bands are not heard. Menu Item 002 should be set to
Figure 4
1
When using stereo headphones, you will hear audio in only one
Figure 5
4
.
MODE 1
Advertisement
Table of Contents
