Trouble Shooting - Asko DC 7181 Use And Care Manual

Trouble Shooting

Before calling for Service check the following.
Trouble Cause
The washing has

not dried as well
as expected






The drying ca-

binet is not gi-
ving out any heat

even though the
temperature se-

lector knob is ac-
tivated.



24
The fuses controlling the drying
cabinet have tripped.
The temperature and/or time se-
lector knobs have not been cor-
rectly set.
The drying cabinet has been used
in a room where the temperature
is lower than 0° C
Washing has been badly spun or
is still very wet.
Has the washing been hung in the
right way?
Has the temperature selector
knob been set too low?
Are the ventilation pipe/hose too
long?
Is it plugged in?
Is the fuse in working order?
Is the right fuse being used?
Has the time selector knob been
set?
The temperature limiter has been
tripped.
The temperature limiter is faulty
What to do
Check

Control the settings

To work normally, the drying

cabinet must obligatorily be
installed in a room where the
temperature is above 0°C
Check what is hanging in the

drying cabinet.
See the section 'Choosing

where to place the washing'.
Control the settings.

They should not be more than

1 metre long.
Check.

Check.

Change to a more resistant

fuse.
Check.

Turn the time selector knob

back to '0'and wait 30 minutes.
Then try again by activating
the temperature selector knob
and, after that, start the fan by
turning on the time selector
knob.
Contact Customer Service.
