Horizontal Adjustment; Mounting - Asko DC 7181 Use And Care Manual

Horizontal adjustment

1. Control that surfaces are horizontal by
placing a bubble level parallel to the walls
and parallel to the back and the door.
2. Use the Allen wrench provided, and cor-
rect the position of all four adjustable feet
through the holes in the base plate of the
drying cabinet (use pliers if necessary).
3. Press the four protective caps down firmly
into the holes.

Mounting

1. Place the drying cabinet in its intended
place, open the door and draw out the
upper hanging section.
2. Drill assembly holes in the wall for the
attachment screws through the two pre-
drilled holes in the back wall of the drying
cabinet.
3. Fix the cabinet in place using the provided
screws and their matching washers. Fit the
plastic plugs (if necessary) into the wall
and also place the plastic spacers bet-
ween the back side of the drying cabinet
and the wall behind it, according to the
figure.
5
4
3
1. Bubble level
2. Allen wrench
6
1. Pre-drilled hole
2. Attachment screws with washers
3. Plastic plug
4. Wall behind the drying cabinet
2
5. Spacer
6. Drying cabinet back wall
1
WARNING
Since the cabinet is very heavy, there
is a risk that it may topple forward.
The cabinet should not be used without
being securely screwed to the wall.
1 2
2
15