Asko DC 7181 Use And Care Manual page 17

7. Fix the two parts of the wooden packer
in place using two screws, each of them
screwed into the wall behind the drying
cabinet, so that they correspond with the
holes marked as in point 4. Use screws of
a suitable length.
8. Slide the drying cabinet back into its final
location. Take off the adhesive tape hol-
ding the door and check that the wooden
packers are in place on the wall bihind the
drying cabinet. Also check that the front
part of the drying cabinet is flush with the
front of the custom cabinetry.
2
1. Screws
2. Hole marking
3. Air flow
4. Wooden packer (in two parts)
5
6
1
~150 mm
9. Adjust the position of the drying cabinet
horizontally according to the instructions
in the section "Horizontal adjustment" on
page 15
10. Draw out the upper hanging section and
drill assembly holes in the wooden packer,
for the attachment screws, through the two
pre-drilled holes in the back wall of the
drying cabinet.
11. Fix the cabinet in place using the provided
attachment screws and their matching
washers.
4
The custom cabinetry with assembled
wooden packers, divided into two parts,
to allow free passage of air
ATTENTION
Check that the wooden packers are
properly and firmly in place on the back
wall and also that the assembly screws
do not obstruct the assembly holes in
the drying cabinet.
The wooden packers are not included
in the delivery.
5. Pre-drilled holes
6. Attachment screws with washers
3
17