Emerson 1410S Reference Manual page 54

Redundant Gateway systems
September 2020
B.3.1 Connect Gateways
After the redundancy system settings have been configured, the two Gateways must be
connected and undergo a pairing process. To pair both Gateways and form a redundant
system:
Procedure
1. Connect a PC/laptop to the primary Ethernet port on Gateway A.
2. Log in using the admin user account.
3. Navigate to System Settings → Gateway → Redundancy Status.
4. Connect the secondary Ethernet port on Gateway A to the secondary Ethernet port
5. After a few minutes, a dialog will appear on the page; select Form redundant pair.
6. Wait for the Pairing to redundant peer status to turn green.
54
The Gateway names will be used in diagnostic messages and host system
integration to help identify each Gateway. It is recommended that these names be
marked on each physical Gateway, in addition to the configuration settings.
Selecting left or right for Gateway A is for visualization purposes only. It has no
effect on performance or functionality.
Figure B-1: System Settings → Gateway → Redundancy
on Gateway B (see Figure B-2).
Reference Manual
00809-0600-4410
Emerson.com