Summary of Contents for Emerson Wireless Gateway 1420
Page 1
Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway Step 1: Initial Connection for Configuration Step 2: Basic Security and Time Configuration Step 3: Basic Ethernet or Serial Configuration Step 4: Mount and Connect the 1420 ¢00825-0100-4420[¤ 1420 Wireless Gateway Start...
Page 3
Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1: I NITIAL To configure the 1420 Wireless Gateway, a local connection between a PC/laptop and the 1420 Wireless Gateway must be established. NOTE: If a PC/laptop from another network is used, carefully record the current IP address and other settings so the PC/laptop can be returned to its original network when configuration of the 1420 is finished.
Page 4
1420 Wireless Gateway c. Select Internet Protocol (TCP/IP), then click the Properties button d. Select the Use the following IP address button and set the IP address to 192.168.1.12 e. Set the Subnet Mask to 255.255.255.0 f. Select OK for each of the settings windows that have opened. 3.
Page 5
Quick Installation Guide 00825-0100-4420, Rev CA June 2007 4. Open a standard web browser (Internet Explorer, Mozilla Firefox or similar). 5. Uncheck proxies (Tools>Internet Options>Connections>LAN Settings) 6. Access the 1420’s default web page at https://192.168.1.10 a. Log on as User: admin b.
Page 6
Quick Installation Guide 00825-0100-4420, Rev CA 1420 Wireless Gateway June 2007 c. Click Yes to proceed through the Security Alert The 1420 Home Page will appear as shown below...
Page 7
Quick Installation Guide 00825-0100-4420, Rev CA 1420 Wireless Gateway June 2007 2: B ASIC ECURITY AND ONFIGURATION To configure the basic security of the 1420 Wireless Gateway, perform the following steps. 1. Navigate to Setup>Security>User Accounts 2. Set and confirm new passwords for each of the access levels 3.
Page 8
1420 Wireless Gateway 3: B ASIC THERNET OR To configure the 1420 for an Ethernet Network: Table 2: Ethernet Communication Settings on page 15 is available to assist in recording the necessary information. 1. Determine 1420 Ethernet Port for connecting to Ethernet Network If using a wired connection, use Port 1 (P1) IT/Process Control Network Administrator or Technician can provide the following: a.
Page 9
Quick Installation Guide 00825-0100-4420, Rev CA June 2007 CONTINUED To configure the 1420 for a Serial connection: Table 4: Serial Communication Settings on page 15 is available to assist in recording the necessary information. 1. Configure 1420 Serial Communication Settings a.
Page 10
1420 Wireless Gateway 4: M OUNT AND Integral Antenna with the 1420 on a Mast The optimal installation of the 1420 Wireless Gateway is on a pole approximately 1.8 meters above the top of the exterior wall of a building. The following hardware and tools are needed: •...
Page 11
Quick Installation Guide 00825-0100-4420, Rev CA June 2007 CONTINUED Connect to Information System 1. Wire the 1420 Primary Ethernet output or Serial Output connection to the Host System Ethernet or Serial input connections. 2. For Serial connections, connect A to A, B to B and make sure all terminations are clean and secured to avoid wiring connection problems.
Rosemount website at www.rosemount.com. A hard copy may be obtained by contacting your local sales representative. ATEX Directive (94/9/EC) Emerson Process Management complies with the ATEX Directive. Electro Magnetic Compatibility (EMC) (2004/108/EC) EN 61326-1: 1997 with amendments A1, A2, and A3– Industrial Radio and Telecommunications Terminal Equipment Directive (R&TTE)(1999/S/EC)
Page 13
Quick Installation Guide 00825-0100-4420, Rev CA June 2007 Canadian Standards Association (CSA) N6 CSA Division 2 & Dust Ignitionproof Certificate Number: See Certificate Suitable for Class I, Division 2, Groups A,B,C,D; Dust Ignitionproof for Class II, Groups E,F, and G; Suitable for Class III Hazardous Locations.
Page 14
Quick Installation Guide 00825-0100-4420, Rev CA 1420 Wireless Gateway June 2007 Figure 3. Terminal and Integration Diagram...
Page 15
Quick Installation Guide 00825-0100-4420, Rev CA June 2007 Table 1. Ethernet Port Locations Settings 1420 Ethernet Port Information System Switch or Access Point Switch or Access Point Ethernet Port Table 2. Ethernet Communication Settings Setting Use Fixed IP or DHCP? Fixed IP Address or DHCP Host Name Netmask (Subnet Mask)
Page 16
Quick Installation Guide 00825-0100-4420, Rev CA 1420 Wireless Gateway June 2007...