D-Link NUCLIAS CONNECT DAP-3666 User Manual page 33

Web User Interface
Enter a value to set the maximum utilization of this access point for service. The DAP-3666 will not allow any new clients to
Network Utilization
associate with the AP if the utilization exceeds the value the user specifies. Select a utilization percentage between 100%, 80%,
60%, 40%, 20%, or 0%. When this network utilization threshold is reached, the device will pause one minute to allow network
congestion to dissipate. The function is only available when Connection Limit is Enabled.
Use the drop-down menu to select the criteria of disconnecting the wireless clients.
Aging out
When Aging out is RSSI, click the drop-down menu to select the percentage of RSSI. When the RSSI of wireless clients is lower
RSSI Threshold
than the specified percentage, the device disconnects the wireless clients. The function is only available when Aging out is RSSI.
When Aging out is Data Rate, click the drop-down menu to select the threshold of data rate. When the data rate of wireless
Data Rate Threshold
clients is lower than the specified number, the device disconnects the wireless clients. The function is only available when Aging
out is Data Rate.
Click the drop-down menu to enable the ACL RSSI function. When enabled, the device denies the connection request from the
ACL RSSI
wireless clients with the RSSI lower than the specified threshold below.
Click the drop-down menu to set the ACL RSSI Threshold.
ACL RSSI Threshold
Click to save the updated configuration. To make the updates permanent, click Configuration > Save and Activate.
Save
D-Link DAP-3666 User Manual 33