Table of Contents
Advertisement
Figure 3 IP Configuration/Setup screen
5
In the In-Band Switch IP Address field, enter the IP address of the switch in dotted-decimal
notation.
Note: If the In-Band Subnet Mask field does not already contain a value when you enter
the IP address in the In-Band IP Address field, the switch software provides an in-use
default value for the In-Band Subnet Mask field. This value is based on the class of the
entered IP address.
6
In the In-Band Subnet Mask field, enter the IP subnet mask address.
7
In the Default Gateway field, enter the default gateway address.
Installing the BayStack 380 10/100/1000 Switch
13
Advertisement
Table of Contents
