Stihl SR 430 Instruction Manual page 13

Fitting the antistatic system – SR 450
only
3
Attach the antistatic wire (1) and
N
chain (2) to the blower housing with
screw (3).
Fitting the pleated hose on the elbow –
SR 450 only
1
2
Push the antistatic wire (1) into the
N
pleated hose (2).
SR 430, SR 450
4
1
Push narrow hose clamp (3), marks
N
facing left, onto the elbow (4).
2
Route the antistatic wire (1) through
N
the slot in the hose clamp (3).
Push the pleated hose (2) onto the
N
elbow (4).
4
Push the hose clamp (3) onto the
N
pleated hose (2).
Line up the marks on the hose
N
clamp (3) and elbow (4) – as shown.
Secure the hose clamp (3) with the
N
screw (5) – make sure the antistatic
wire is located in the notch.
3
2
1
3
2
5
4
5
3
Adjusting and securing the control
handle
Put the machine on your back and
N
adjust the harness – see "Harness".
a
1
Slide the control handle (1) along
N
the tube to the most comfortable
position – distance between nozzle
outlet (2) and the control handle (1)
must be at least 500 mm ('a').
1
Secure the control handle (1) with
N
the screw (3).
English
2
3
11