Trane Thermo King TriPac EVOLUTION Installation Manual page 61

Standby Truck Integration Harness without Switch
(Option)
Special Tools Required
Digital Meter (204-615)
Access the tractor's ignition switch wires at rear of the switch:
a. Turn ignition switch to the " " A A C C C C E E S S S S O O R R Y Y " " position and use a digital meter to locate a wire connection with NO
POWER (0 Vdc).
b. Turn ignition switch to the " " O O N N " " position and re-check for voltage at the same wire connection tested earlier. If
voltage is present, this is where the IGN wire will be connected.
1. Connect I I G G N N wire with in-line fuse to:
WIRE
IGN
2. Route the standby switch harness to the control box and connect the 2-pin connector ( ( S S B B Y Y a a n n d d 2 2 A A ) ) to the mating
pigtail connector found on the main harness installed earlier.
D D P P F F U U n n i i t t s s O O n n l l y y
Install the DPF regeneration switch now. Refer to TK 55727-19-IM for details.
TK 55676-19-IM-EN
VEHICLE CONNECTION
"ON" circuit of ignition switch
or
"ON" circuit of fuse panel
61