Configuration Port Commands (Cont.)
Command
SET LOG COUNT
SET QUEUE SIZE
SET SSH PORT
SET TELNET PORT
NI-3101-SIG Signature Series NetLinx Integrated Controller
Description
Sets the number of entries allowed in the message log.
Example:
>SET LOG COUNT
Current log count = 1000
Enter new log count (between 50-10000) :
Once you enter a value and press the ENTER key, you get the following
message:
Setting log count to
New log count set, reboot the Master for the change to
take affect.
Provides the capability to modify maximum message queue sizes for vari-
ous threads.
Example:
set queue size
This will set the maximum message queue sizes for several threads.
Use caution when adjusting these values.
Set Queue Size Menu:
1. Interpreter (factory default=2000, currently=600)
2. Notification Manager (factory default=2000, currently=200)
3. Connection Manager (factory default=2000, currently=500)
4. Route Manager (factory default=400, currently=200)
5. Device Manager (factory default=500, currently=500)
6. Diagnostic Manager (factory default=500, currently=500)
7. TCP Transmit Threads (factory default=600, currently=200)
8. IP Connection Manager (factory default=800, currently=500)
9. Message Dispatcher (factory default=1000, currently=500)
10. Axlink Transmit (factory default=800, currently=200)
11. PhastLink Transmit (factory default=500, currently=500)
12. ICSNet Transmit (factory default=500, currently=500)
13. ICSP 232 Transmit (factory default=500, currently=500)
14. UDP Transmit (factory default=500, currently=500)
15. NI Device (factory default=500, currently=500)
Enter choice or press ESC.
Sets the IP port listened to for SSH connections.
Example:
>SET SSH PORT
Current SSH port number = 22
Enter new SSH port number (Usually 22) (0=disable SSH) :
Once you enter a value and press the ENTER key, you get the following
message:
Setting SSH port number to 22
New SSH port number set, reboot the Master for the change to
take affect.
Sets the IP port listened to for Telnet connections.
Example:
>SET TELNET PORT
Current telnet port number = 23
Enter new telnet port number (Usually 23) (0=disable Telnet) :
Once you enter a value and press the ENTER key, you get the following
message:
Setting telnet port number to 23
New telnet port number set, reboot the Master for the
change to take affect.
Programming
147