AMX NetLinx NI-3101-SIG Operation/Reference Manual page 148

Programming
Configuration Port Commands (Cont.)
Command
GET DUET MEMORY
GET ETHERNET MODE
GET IP <D:P:S>
HELP SECURITY
ICSPMON ENABLED|DISABLED
[PORT]
IP STATUS
MEM
MSG ON or MSG OFF
142
Description
Display the amount of memory allocated for Duet Java pool. This is the
current Java memory heap size as measured in Megabytes.
An example is a value of 5 = 5 MB.
Displays the current ethernet configuration setting.
Settings are either "auto" in which the ethernet driver will discover it's set-
tings based on the network it is connected to OR <speed> and <duplex>
where speed is either 10 or 100 and duplex is either full or half.
Example:
get ethernet mode
Ethernet mode is auto.
Note: See SET ETHERNET MODE.
Displays the Master's D:P:S, Host Name, Type (DHCP or Static), IP
Address, Subnet Mask, Gateway IP, and MAC Address.
Example:
>GET IP [0:1:50]
IP Settings for 0:1:50
HostName MLK_INSTRUCTOR
Type DHCP
IP Address 192.168.21.101
Subnet Mask 255.255.255.0
Gateway IP 192.168.21.2
MAC Address 00:60:9f:90:0d:39
Displays the related security commands:
Example:
>HELP SECURITY
>logout Logout and close secure session
>setup security Access the security setup menus
Enables or disables ICSP monitoring out the specified IP port.
By enabling icspmon on an IP port, an external application could connect
to that port and "listen" on the ICSP traffic.
Provides information about the current NetLinx IP Connections:
Example:
>IP STATUS
NetLinx IP Connections
No active IP connections
Displays the largest free block of the Master's memory.
Example:
>MEM
The largest free block of memory is 11442776 bytes.
MSG On sets the terminal program to display all messages generated by
the Master. MSG OFF disables the display.
Example:
> MSG ON
Extended diagnostic information messages turned on.
> MSG OFF
Extended diagnostic information messages turned off.
NI-3101-SIG Signature Series NetLinx Integrated Controller