Charging The Nxt-Bp Batteries With The Nxa-Base/B - AMX Modero NXT-1500VG Operation/Reference Manual

Touch Panel Accessories
NXT-BP Battery #2
Battery
Compartment
FIG. 30 Battery installation procedure
3. Align the battery connectors with the corresponding battery connector port (located inside the
battery compartment), as shown in FIG. 30.
4. Insert the NXT-BP battery until the connectors securely fit into the battery connector port.
5. Repeat steps 2 through 4 for the other battery.
6. Apply a small amount of pressure to close the battery compartment until the compartment latches.

Charging the NXT-BP batteries with the NXA-BASE/B

1. Follow the procedures from the previous sub-section to attach the NXT touch panel to the
NXA-BASE/B.
2. Insert each battery into the battery compartment shown in FIG. 30.
3. Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT Modero panel.
The NXA-BASE/B will only charge batteries when the NXT panel is in Sleep mode.
48
Battery
Connector
Port
Battery #2
slot
After a few seconds, the panel will turn On and the AMX logo will appear (indicating the
panel is receiving power.
The charge status bargraph indicators, on the Battery Base page, indicate when the batteries
are fully charged.
Battery
Connectors
Interface
connector
FRONT
NXT-BP Battery #1
VG-Series Modero Touch Panels