2. Install the NXT-BP battery. label-side down.
3. Align the battery connectors with the corresponding battery connector port (located inside the
battery compartment), as shown in FIG. 29.
4. Insert the NXT-BP battery until the connectors securely fit into the battery connector port.
5. Repeat steps 2 through 4 for the other battery.
6. Apply a small amount of pressure to close the battery compartment until the compartment latches.
Charging the NXT-BP batteries with the NXA-BASE/B
1. Follow the procedures from the previous sub-section to attach the NXT touch panel to the
NXA-BASE/B.
2. Insert each battery into the battery compartment shown in FIG. 29.
3. Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT Modero panel.
The NXA-BASE/B will only charge batteries when the NXT panel is in Sleep mode.
NXT-CHG Battery Charger Kit (FG2255-50K)
The NXT-CHG Kit includes one charger and two batteries. The optional NXT-CHG Modero Power
Station (FIG. 30) is a two-slot, stand-alone battery charger that can be used to recharge up to two
NXT-BP batteries. The batteries are charged in the order they are inserted into the charger. The
NXT-CHG Slot 1 has the feature of being able to completely discharge and recharge (recalibrate) a
battery.
NXT-CHG Modero Power Station (charger)
FIG. 30
NXT-CHG Kit (consists of one NXT-CHG charger and two NXT-BP batteries)
1200V Modero Video Touch Panels
After a few seconds, the panel will turn On and the AMX logo will appear (indicating the
panel is receiving power.
The charge status bargraph indicators, on the Battery Base page, indicate when the batteries
are fully charged.
NXT-BP Modero Power Pack (battery)
Touch Panel Accessories
Battery Life indicator
29